IS200RCSAG1A
IS200RCSAG1A
IS200RCSAG1A
保护财产及人身安全:
●保护设备和线路，防止过载及短路造成的损害
●防止由于绝缘故障引起的间接接触的危险
要遵守的条件:
●按照IEC 60364 § 60473-1-1
●在各回路的首端，分支路出口(电流减小)
保护电器的分类
●低压断路器
●低压熔断器
●剩余电流动作保护器第一部分 变压器与母线槽、断路器配合推荐表
第二部分 Trihal 干式变压器选型指南
第三部分 Busway 母线槽选型表
第四部分 Smart Panels智能配电系统选型指南?
第五部分 空气断路器选型指南
第六部分 塑壳断路器、负荷/隔离开关选型指南
第七部分 双电源自动转换开关及系统选型指南
第八部分 低压终端配电产品选型指南
第九部分 SPD电涌保护器选型方案
第十部分 Power Solution 电能管理选型指南
第十一部分 低压成套设备选型指南
第十二部分 电动机控制保护产品选型指南
第十三部分 电动机回路配合选型表
第十四部分 软起动器产品选型指南
第十五部分 ATV系列低压变频器选型指南
第十六部分 智能照明控制系统选型表
第十七部分 WEFP电气火灾WPFP消防设备电源监控系统选型指南
第十八部分 UPS电源和精密空调电源选型指南
operating parameters
c
complete self-diagnosis
Compact and robust design
Front Panel Wiring
DIN rail (U-shaped) installation well can be directly wall mounted, simple and convenient
o
Allowable operating ambient temperature…60 C, with automatic temperature monitoring
o
EMC (Electromagnetic Compatibility) according to EN50082
mouth
Certifications: CE, NAMUR, CSA, CSA-NRT
Glossary
Process station:
This term is used to describe AC800F controllers (field controllers) and rack-mounted controllers. A process station can be designed to be redundant
configuration and non-redundant configuration.
AC800F :
This term is used to describe the AC800F Field Controller type of process station. A redundant process station consists of 2
AC800F controller.
Rack mounted process station:
This term is used to describe a rack-mounted type of process station. A redundant process station contains 2 rack-mounted CPUs.
This term is used to describe a single, non-redundant process station.
In the investment of modern automation system, due to the hardware equipment department
It only takes up less cost in the whole system, then write engineering applications
The cost of software becomes increasingly important. Generally speaking, a self
The engineering application software cost of the automation project accounts for about the entire project.
About 50%, it is not difficult to see that the migration of cost structure creates a lot of innovation for users.
Create an opportunity to optimize project investment, therefore, it is necessary to start from engineering programming
Think about lowering costs in the first place!
This is what we developed the Freelance 800F system for:
Keeping hardware prices consistent with those of programmable logic controllers
In this way, cost efficiency can be improved by reducing user engineering costs.
How the Freelance 800F process control system helps users reduce
Low engineering cost?
●By using a complete engineering tool (Control Builder
F) to configure the entire control system, including automation functions
function, operator interface
