A404k
A404k
A404k
BMX MSP 0200 模块是一种标准格式模块，用于以兼容开路集电极的输入以及集成式位置控制回路来控制第三方驱动器。
此模块具有 2 个脉冲串输出 (PTO) 通道。
MSP 0200 PTO 模块的主要用途是通过开集输入和集成式位置回路控制第三方设备。
PTO 模块针对指定的脉冲数和指定的循环时间提供了一个方波输出。可以将它编程为生成一个脉冲串或一个由多个脉冲串组成的脉冲包络。
例如，可以使用脉冲包络，通过一个简单的斜升、运行和斜降序列或多个复杂的序列来控制步进电机或伺服电机。
根据开环模式实现了定位控制，意味着不需要关于运动物体实际位置的反馈信息。
thin cable communication interface
Ei802f provides 10BASE5 thick cable connection (through AUI interface)
Ei803f provides 10Base-T twisted pair communication interface
32-bit data bus, 100 mb/s
DMA (direct memory access) mode main memory ram, corresponding CPU operating load <4%
Optional ram backup battery
Fieldbus interface replacement card fi830f/fi820f/fi810f
Fieldbus interface cards are divided into several types according to different protocol standards. Ea
ch interface card provides – a fieldbus interface (PROFIBUS,
Can, FF, MODBUS, etc.). The configuration and parameter settings of the interface card itself and the field instrument (or remote i1/0) on the connected fieldbus are still
It is designed by the industrial “unified tool control bui lder without additional software. The interface card can be configured redundantly (separated between each other
Redundant basic unit pm802f) and can be plugged in and out and replaced online.
Fi830f: PROFIBUS DP interface card, as the master station, can connect 126 PROFIBUS DP slave stations, and the communication rate can reach 12mbd
One PS can plug in 4 fieldbus interfaces, connect 496 fieldbus devices, and one city (subsystem) of industrial “system can
Connect 4960 fieldbus devices (10000 i/0).
Fi820f: two serial interfaces are provided to connect the serial protocol equipment. The maximum transmission rate is 38.4kbd and can be configured. Its Standards Association
Modbus Different physical interfaces can be selected for different connection schemes, RS422, RS485, RS232. All interfaces are electrical isolation
Away. And the redundant operation is realized by two redundant field controllers.
Fi8i0f card is a triple can bus protocol interface card (rate 1mbd) used to connect industrial ial “conventional process control station
The i/0 protection unit of the PS is used to receive process signals from the rack mounted i/0 modules supported by the PS. Each field controller PS can only be configured
-Block fi810f card. — The two fi810f
