5. 3系统工程组态与调试维护工具软件CBP (Control Builder F)
CBF:是Industrial “DCS控制系统的工程工具，它是集组态(包括硬件配置、控制策略、HIS即人机
接口等组态)、工程调试和诊断功能为- -体的工具软件包。CBF采用统- -的 系统全局数据库和强大的交
叉参考工具，不仅能方便地完成自动化组态，而且是一个高性能的过程调试工具。Industrial”DCS系
统过程控制站PS所需的各种控制算法和策略都是由CBF来组态的，井采用图形化的组态方法(符合
1EC61131- 3标准)。
CBF也用于对操作站人机接口(HIS)功能的组态并还可直接对现场总线设备进行组态。
控制算法和策略组态可选用以下IEC 61131-3标准组态方法中的一-种或几种:
FBD (功能方块图 )
JD (梯形图)
SFC (顺序功能图 )
IL (指令表)
sT (结构化文本)
CBF安装在Industrial “系统工程师站上，完成后的组态结果由工程师站通过系统网络下载至相应
的现场控制器PS及操作站0S中。组态既可在线也可离线。
cables and mixed media) and network topology can be selected for the system bus.
Simple layout, due to the use of TCP/IP protocol, the system can also use the public telephone network (dial-up mode) or satellite to achieve ultra-long-distance communication.
Subsystems such as PLC communicate with the Industrial” system through the ModBus protocol interface. The system also supports IEC870-5 over-control protocol.
discussion.
The Flash EPROM inside the PS provides more than 220 functional modules (control algorithm subroutines), in addition to the basic ones specified in the IEC 61131 3 standard
In addition to this content, many powerful and rigorously tested function blocks from actual engineering applications have been expanded. any complex control
The scheme can be realized by the combination of these function blocks.
The function blocks provided by the system mainly include the following
