FRD的组态步骤如下:
1.定义FBD程序名称
5
2.调用FBD编辑器
功能&功能块
3.选择所需功能或功能块
4.将功能块放置在图形工作区
5.用信号流向线连接各功能块
6.键入输入输出变量
7.定义功能块参数
8.编译FBD程序
9.纠正语法错误
控制策略组态方法_顺序功能圉(SPC)
利用顺序功能图SFC可以方便地生成清晰的、图形化的顺序控制程序。要建立- -个SFC,需组态
要被执行的任务(命令)步(step)和允许执行下-步的步进条件(transition)，并为步和步进条件分配
功能块图、指令表或梯形图程序.顺序功能图的另-特性是能够产生选择性或并列性分支及对顺序结
构进行同步。完成一个顺序功能图(SFC)控制程序组态的同时，也自动生成- -个用于操作站上显示的
SFC画面。
protocol equipment. The maximum transmission rate is 38.4kbd and can be configured. Its Standards Association
Modbus Different physical interfaces can be selected for different connection schemes, RS422, RS485, RS232. All interfaces are electrical isolation
Away. And the redundant operation is realized by two redundant field controllers.
Fi8i0f card is a triple can bus protocol interface card (rate 1mbd) used to connect industrial ial “conventional process control station
The i/0 protection unit of the PS is used to receive process signals from the rack mounted i/0 modules supported by the PS. Each field controller PS can only be configured
-Block fi810f
